About Author

Display system declaration switch

by ShahedNovember 5, 2015November 13, 20150

Display system declaration switch Display system declaration switch command is used to query the status of the law declaration switch. When you need to query whether the law declaration switch is enabled, run this command. [boxads] Format: Modes: Common user mode Level: Common user level Usage Guidelines: You can run the system declaration switch command to configure the law declaration switch. Example: To query the law declaration switch, do as follows: System Response: The system displays the message “Declaration switch : xx” after the command is executed successfully. “xx” is “On” or “Off”, depending on the actual state of the …

by ShahedNovember 5, 20150

Display section-details Huawei OLT Display section-details command is used to query the information about the types of all the registered and activated sections. To query the information about the types of all the registered and activated sections, run this command. [boxads] Format: display section-details Modes: Privilege mode Level: Common user level Example: To query the information about the types of all the registered and activated sections, do as follows: BD-Huawei#display section-details [global-config] <global-config> [device-config] <device-config> [public-config] <public-config>

by ShahedNovember 4, 20150

Display Client Huawei OLT Display Client command is used to query the information on the current login users. When you need to query the user number, IP address, and login time of the current login user to ease security management, run this command. [boxads] Format: display client Modes: Common user mode Level: Common user level Usage Guidelines: Using this command, you can view the current login users whose levels are equal to or lower than yours. The super user can view the information about all the login users. The administrator can view the information about the administrator users, operator users, …

by ShahedNovember 4, 2015November 4, 20150

Client Kickoff Huawei OLT Client Kickoff command is used to disconnect an end user. When the administrator needs to disconnect the user from the server if the insecurity operations of a user or users with the same level are found, run this command. After that, the user cannot perform any operation to the system. [boxads] Format: client kickoff clientid Clientid: clientid Indicates the end user number. Each end user has the only number. When you need to disconnect the specified end user, use this parameter.

by ShahedNovember 4, 20150

Clear Terminal user login failure: Clear Terminal user login failure command is used to clear the information about the failed logins of all the users in the system. When you need to clear the information about the failed logins of all the users in the system, run this command. After the command is executed successfully, the information about the failed logins of all the users in the system is cleared. [boxads] Format: clear terminal user login failure Parameters: None Modes: Privilege mode Level: Super user level Usage Guidelines You can run the display terminal user login failure command to query …

by ShahedNovember 4, 2015November 4, 20150

Board Series-name Huawei OLT Board Series-name command is used to configure the alias function of the serialized boards. [boxads] Before setting names for serialized boards, you must enable the alias function. After the function is enabled, you can set the alias for serialized boards when adding the boards offline. After the setting, the preset names are displayed as the default name of serialized boards. Format: board series-name { enable | disable } Enable: Enables the alias function. To set names for serialized boards when adding the boards offline, use this parameter. Disable: Disables the alias function. When you do not …