GEM Port Configure ZTE OLT | GPON Solution

GEM Port Configure ZTE OLT

GEM Port Configure ZTE OLT

Today i will discuss how to GEM Port Configure ZTE OLT.

Prerequisites:

  • Make sure network device works normally.
  • Make sure GPON card works normally.
  • Make sure T–CONT is configured.
  • Log in to the ZXA10 C220 through HyperTerminal or Telnet.

Context:

GEM port is the minimum unit of downstream traffic which is identified by port ID.

To configure the GEM port, performs the following steps:

Step-1. Use the configure terminal command to enter global configuration mode.
Step-2. Use the interface command to enter the GPON-ONU interface configuration mode.
Step-3. Use the gemport command to configure GEM port

Example of GEM Port Configure ZTE OLT:

Now we Configure a GEM port.

  • GPON-ONU port: 0/5/1:1
  • T-CONT index: 2
  • GEM port index: 1
  • GEM port name: Gemport1

ZXAN#configure terminal
Enter configuration commands, one per line. End with CTRL/Z.
ZXAN(config)#interface gpon-onu_0/5/1:1
ZXAN(config-if)#gemport 1 name Gemport1 unicast tcont 2

GEM Port Configure ZTE OLT

GEM Port Configure ZTE OLT

email

Shahed

Hi! I am Shahed. I currently work as a Sr. Network Engineer. I want to build up my carrier in Networking field.

Follow Me:
TwitterFacebookLinkedInPinterestGoogle PlusDiggYouTubeRedditDelicious

GEM Port Configure ZTE OLT was last modified: April 16th, 2016 by Shahed

Comments

comments

Leave a Reply

Your email address will not be published. Required fields are marked *

Time limit is exhausted. Please reload CAPTCHA.

error: Content is protected !!