CAC Configure in ZTE OLT
[boxads]
Today i will discuss how to CAC Configure in ZTE OLT.
Prerequisites:
- Make sure that the network device works normally.
- Make sure that the data service is configured.
- Make sure that theIPTV package is configured.
- Log in to the ZXA10 C220 through HyperTerminal or Telnet.
Context:
To configure the CAC, perform the following steps:
1. Use the configure terminal command to enter global configuration mode.
2. Use the iptv cac command to enable global CAC function.
3. Use the interface command to enter the GPON-ONU interface configuration mode.
4. Use the iptv service start command to start IPTV service on the interface.
5. Use the iptv right-mode command to enable or disable the authentication on the interface.
Note: By default, the authentication enabled.
6. Use the iptv-mode command to configure interface right mode.
Note: The default right mode is package.
7. Configure interface right.
Use the iptv channel command to configure the interface channel.
Use the iptv package command to configure the interface package.
Note: The default right mode is package. When a package is applied to an interface, the IPTV service is started automatically.
[bodyads]
CAC Configure Example:
- GPON-ONU port: 0/5/1:1
- Global CAC function: Enable
- ONU CAC right mode: package
- ONU IPTV package: pkg1
ZXAN#configure terminal
Enter the configuration commands, one per line. End with CTRL/Z.
ZXAN(config)#iptv cac enable
ZXAN(config)#interface epon-onu_0/5/1:1
ZXAN(config-if)#iptv right-mode package
ZXAN(config-if)#iptv package pkg1 vport 1
