Troubleshoot commands of Huawei ONT | GPON Solution

Troubleshoot commands of Huawei ONT

Troubleshoot commands of Huawei ONT:

Huawei OLT Troubleshoot commands:

To show Service port:

Huawei-OLT(config)#display service-port 500

To show Service port by port:

Huawei-OLT(config)#display service-port port 0/0/6 ont 0

[Here PortID :6, ONTID :0 ]

To Show ONT Info:

Huawei-OLT(config)#interface gpon 0/0
Huawei-OLT(config-if-gpon-0/0)#display ont info 6 0

To Show Port State [Port up/down]:

Huawei-OLT(config-if-gpon-0/0)#display ont port state 6 0 eth-port all
Huawei-OLT(config-if-gpon-0/0)#display ont port attribute 6 0 eth 1

To Show Statistics:

Huawei-OLT(config-if-gpon-0/0)#display statistics ont-eth 6 0 ont-port 1

To Show Traffic:

Huawei-OLT(config-if-gpon-0/0)#display ont traffic 6 0 1

To Show Optical Info:

Huawei-OLT(config-if-gpon-0/0)#display ont optical-info 6 0    [6=port, 0=ONT id]

To Show MAC Address:

Huawei-OLT#display mac-address port 0/0/6
Huawei-OLT#display mac-address vlan 2816
Huawei-OLT#display mac-address service-port 500

To Reset ONT:

Huawei-OLT(config-if-gpon-0/0)#ont reset 6 0

Add ip on a vlan interface:

Huawei-OLT(config)#interface vlanif 2816
Huawei-OLT(config-if-vlanif2816)#ip address



Hi! I am Shahed. I currently work as a Sr. Network Engineer. I want to build up my carrier in Networking field.

Follow Me:
TwitterFacebookLinkedInPinterestGoogle PlusDiggYouTubeRedditDelicious

Troubleshoot commands of Huawei ONT was last modified: October 26th, 2015 by Shahed



2 Responses to Troubleshoot commands of Huawei ONT

  1. Suzu says:

    Dear sir ,
    Kindly help me to change vlan on ONT .

Leave a Reply

Your email address will not be published. Required fields are marked *

Time limit is exhausted. Please reload CAPTCHA.

error: Content is protected !!