Commands

Commands

Huawei OLT user parameter

by

Huawei OLT user parameter If you want to query the system parameters of a user in Huawei OLT then use command: display system user parameter Usage Guidelines You can query the following parameters: Lock type Lock conditions Lock duration Lock duration when the system is idle Switch status for password change upon first login Minimum … Read more

System lock Condition Huawei OLT

by

System lock Condition Huawei OLT This system lock condition failure_times command is used to configure the lock condition for the user and the terminal IP address. When you need to lock the user and the terminal IP address after the password is entered incorrectly for a preset count, run this command. After the command is executed … Read more

System encoding Huawei OLT

by

System encoding Huawei OLT System encoding command is used to configure the encoding mode of the system. When you need to change the encoding mode of the system, run this command. [boxads] The undo system encoding command is used to restore the default encoding mode of the system. When you need to restore the default … Read more

System declaration switch

by

System declaration switch System declaration switch command is used to set the law declaration switch. To enable users to acknowledge and accept the law declaration so as to avoid illegal operations, run this command. After this command is executed successfully, the status of the law declaration switch is changed to the specified status (enable or … Read more

Super password & only super

by

Super password & only super super password command is used to configure the password for the higher user level which is switched from a lower user level. Before you run the super command to switch a user level to a higher user level, run this command to configure the password for the higher user level. … Read more

Load declaration Huawei OLT

by

Load declaration Huawei OLT

Load declaration command is used to load the law declaration file. The law declaration is the prompt or warning shown when a user logs in to the system. If the law declaration is set to be shown, the system shows the law declaration information when a user logs in to the system. In this case, the user is required to decide whether to accept the law declaration. After accepting the law declaration, the user can log in to the device. Otherwise, logging in to the device fails.

[boxads]

Format:

load declaration { xmodem |tftp ServerIpAddress filename | ftp ServerIpAddress filename | sftp ServerIpAddress filename } options

xmodem: Loads data through the serial port using the Xmodem protocol. When the embedded HyperTerminal of the operation system is used for configuring the serial port, use this parameter. There is no need to use networking for loading the serial port and no need to install the software of the NMS to maintain the system through the CLI.

Read more