GPON

Dying gasp Alarm GPON Huawei ONTi (DGi)

by

Dying gasp Alarm GPON ONTi (DGi)

When ONT goes offline then Huawei OLT receives a message from ONT then system generates dying gasp alarm. If power cord remove from ONT without power off ONT device or Load shedding causes electricity power go away then system generates dying gasp alarm.

[boxads]

Attribute:

Alarm ID Alarm Severity Alarm Type
0x2e11a00b Minor Fault
Dying gasp Alarm GPON Huawei ONTi (DGi)
Dying gasp Alarm GPON Huawei ONTi (DGi)

Parameters:

Name Meaning
FrameID The ID of the shelf where the alarm is generated.
SlotID The ID of the slot where the alarm is generated.
PortID The ID of the port where the alarm is generated.
ONT ID The ID of the ONT where the alarm is generated.
Equipment ID The ID of the equipment where the alarm is generated.
Description of the ONT(Only for NMS) The description of the ONT (only available on the NMS), which can be used to distinguish different ONTs.

Read more

Key Differences Between GPON SFP Class B+ and C+

by

Key Differences Between GPON SFP Class B+ and C+ [boxads] The Key Differences Between GPON SFP Class B+ and C+ are their TX power and RX Sensitive. Class B+ OLT transceiver: TX power 1.5~5db, RX sensitive -28db. Class B+ ONU transceiver: : TX power 0.5~5db, RX sensitive -27db. Class C+ OLT transceiver: TX power 3~7db, … Read more

System encoding Huawei OLT

by

System encoding Huawei OLT System encoding command is used to configure the encoding mode of the system. When you need to change the encoding mode of the system, run this command. [boxads] The undo system encoding command is used to restore the default encoding mode of the system. When you need to restore the default … Read more

System declaration switch

by

System declaration switch System declaration switch command is used to set the law declaration switch. To enable users to acknowledge and accept the law declaration so as to avoid illegal operations, run this command. After this command is executed successfully, the status of the law declaration switch is changed to the specified status (enable or … Read more