Configure redirection ZTE OLT

Configure redirection ZTE OLT

[boxads]

Today i will discuss how to Configure redirection ZTE OLT.

Prerequisites:

• Make sure that the network device works normally.
• Log in to the ZXA10 C220 through HyperTerminal or Telnet.

Context:

Redirection modifies egress direction of packet according to traffic classification. The direction may be next hop, CPU or interface.

To configure the redirection, perform the following steps:

Step-1. Use the configure terminal command to enter global configuration mode.
Step-2. Use the acl command to configure ACL.
Step-3. Use the rule command to configure ACL rule.
Step-4. Use the redirect in command to configure redirection.
Step-5. Use the interface command to enter interface configuration mode.
Step-6. Use the ip access-group command to apply the ACL to port.
Example of Configure redirection ZTE OLT:

• Configure redirection on uplink port 0/14/4:
• Redirection port for packets from source IP address 168.2.5.5: 0/14/3
• Next hop for packets from source IP address 66.100.5.6: 166.88.96.56

[bodyads]
ZXAN#configure terminal
Enter configuration commands, one per line. End with CTRL/Z.
ZXAN(config)#acl extend number 100
ZXAN(config-ext-acl)#rule 1 permit ip 168.2.5.5 0.0.0.0 any
ZXAN(config-ext-acl)#rule 2 permit ip any 66.100.5.6 0.0.0.0
ZXAN(config-std-acl)#rule 3 permit any
ZXAN(config-ext-acl)#exit
ZXAN(config)#redirect in 100 rule-id 1 interface gei_0/14/3
ZXAN(config)#redirect in 100 rule-id 2 next-hop 166.88.96.56
ZXAN(config)#interface gei_0/14/4
ZXAN(config-if)#ip access-group 100 in

Shahed

Hi! I am Shahed Israr. I try to help GPON Technology users with their queries and provide them with relevant and accurate information to the best of my ability. My main goal is to assist and enhance GPON Technology user and help people find the answers they're looking for quickly and easily.

Follow Me:

Comments

comments