Display system declaration switch | GPON Solution

Display system declaration switch

Display system declaration switch

Display system declaration switch command is used to query the status of the law declaration switch. When you need to query whether the law declaration switch is enabled, run this command.

Format:
declaration switch

Modes:
Common user mode

Level:
Common user level

Usage Guidelines:
You can run the system declaration switch command to configure the law declaration switch.

Example:
To query the law declaration switch, do as follows:

System Response:

  • The system displays the message “Declaration switch : xx” after the command is executed successfully. “xx” is “On” or “Off”, depending on the actual state of the law declaration switch.
email

Shahed

Hi! I am Shahed. I currently work as a Sr. Network Engineer. I want to build up my carrier in Networking field.

Follow Me:
TwitterFacebookLinkedInPinterestGoogle PlusDiggYouTubeRedditDelicious

Display system declaration switch was last modified: November 13th, 2015 by Shahed

Comments

comments

Leave a Reply

Your email address will not be published. Required fields are marked *

Time limit is exhausted. Please reload CAPTCHA.

error: Content is protected !!