About Author

Key Differences Between GPON SFP Class B+ and C+

by ShahedDecember 12, 2015December 12, 20158

Key Differences Between GPON SFP Class B+ and C+ [boxads] The Key Differences Between GPON SFP Class B+ and C+ are their TX power and RX Sensitive. Class B+ OLT transceiver: TX power 1.5~5db, RX sensitive -28db. Class B+ ONU transceiver: : TX power 0.5~5db, RX sensitive -27db. Class C+ OLT transceiver: TX power 3~7db, RX sensitive -32db. Class C+ ONU transceiver: : TX power 0.5~5db, RX sensitive -30db. When you configure the MA5683T, MA5680T, MA5600T, MA5608T, MA5603T… have the the confuse: what is The Key Differences Between GPON SFP Class B+ and Class C+ transceiver? Here we will solve the …

by ShahedNovember 13, 2015November 13, 20150

System lock Condition Huawei OLT This system lock condition failure_times command is used to configure the lock condition for the user and the terminal IP address. When you need to lock the user and the terminal IP address after the password is entered incorrectly for a preset count, run this command. After the command is executed successfully, when the password is entered incorrectly for the count of failure_times, the user and the terminal IP address are locked and cannot log in. [boxads] This system lock condition idle_timeout command is used to configure the idle lock time of the user. After the …

by ShahedNovember 13, 20150

System encoding Huawei OLT System encoding command is used to configure the encoding mode of the system. When you need to change the encoding mode of the system, run this command. [boxads] The undo system encoding command is used to restore the default encoding mode of the system. When you need to restore the default encoding mode of the system, run this command. After you run the undo system encoding command, the system uses the GBK encoding mode. Format: CodeMode is the system encoding mode. Enumerated type. Options: GBK, ISO8859-1, and UTF-8. GBK: Indicates that the GBK encoding mode is …

by ShahedNovember 13, 2015November 13, 20150

System declaration switch System declaration switch command is used to set the law declaration switch. To enable users to acknowledge and accept the law declaration so as to avoid illegal operations, run this command. After this command is executed successfully, the status of the law declaration switch is changed to the specified status (enable or disable). [boxads] Format: on-off: Sets the law declaration switch. Enumerated type. Options: enable, and disable. enable: displays the law declaration after the user logs in. disable: displays no law declaration after the user logs in. This command use Administrator level & Privilege mode. Usage Guidelines: …

by ShahedNovember 13, 2015November 13, 20150

Super password & only super super password command is used to configure the password for the higher user level which is switched from a lower user level. Before you run the super command to switch a user level to a higher user level, run this command to configure the password for the higher user level. [boxads] The undo super password command is used to recover the default user level. After this command is successfully executed for a user, the user level cannot be switched to a higher user level. Format: super password level user-level { simple simple | cipher cipher …

by ShahedNovember 13, 20150

Load declaration Huawei OLT Load declaration command is used to load the law declaration file. The law declaration is the prompt or warning shown when a user logs in to the system. If the law declaration is set to be shown, the system shows the law declaration information when a user logs in to the system. In this case, the user is required to decide whether to accept the law declaration. After accepting the law declaration, the user can log in to the device. Otherwise, logging in to the device fails. [boxads] Format: load declaration { xmodem |tftp ServerIpAddress filename …