Huawei OLT Autosave Configuration enable/on
[boxads]
Today i will discuss how to enable/on Huawei OLT Autosave Configuration. Two way we can do it, one is autosave interval and another is autosave time.
This command is used to enable the system to save the system configuration automatically or set the preset time when the configuration is saved. The autosave function includes autosave configuration at the preset time and at the interval time. When you need to set the preset time of the autosave function, run this command. After the command is executed successfully, you can save the configuration at the preset time instead of delivering commands by the network management to prevent data loss at emergency reboot.
- By default, the auto-save function is disabled.
- When the autosave function is enabled, if the system configuration is modified, the configuration is saved at the user-defined time. When the autosave function is disabled, the configuration is not saved automatically, and you need to run the save command to save it.
- When you enable the autosave function, pay attention to the following points:
- This function autosave time and the autosave interval function cannot be enabled simultaneously.
- When you run the autosave interval command, saving data frequently affects the system. Therefore, it is not recommended that you configure the auto-save interval smaller than one hour. The recommended value is equal to or greater than 24 hours.
- Writing and reading the data in the flash memory frequently decreases the using time of the flash memory. It is recommended to disable this function after the configuration.
Huawei OLT Autosave Configuration enable Example:
To enable the auto-save function, do as follows:
huawei#autosave interval
{ configuration<K>|time<U><10,10080>|value<E><on,off> }:on
Command:
autosave interval on
System autosave interval switch: on
Autosave interval: 1440 minutes
Autosave type: data
System autosave modified configuration switch: on
Autosave interval: 30 minutes
Autosave type: data
To set the auto-save interval to 120 minutes based on the relative time of the system, do as follows:
huawei#autosave interval
{ configuration<K>|time<U><10,10080>|value<E><on,off> }:120
Command:
autosave interval 120
System autosave interval switch: on
Autosave interval: 120 minutes
Autosave type: data
To set the auto-save interval to 60 minutes for saving the modified configuration data of the system, do as follows:
huawei#autosave interval
{ configuration<K>|time<U><10,10080>|value<E><on,off> }:configuration
{ time<U><2,1440> }:60
Command:
autosave interval configuration 60
System autosave modified configuration switch: on
Autosave interval: 60 minutes
Autosave type: data
GPON Huawei ONT Capability