ZTE OLT Rack Shelf Configure
[boxads]
Today i will discuss how to add ZTE OLT Rack Shelf by CLI mode.
Rack Configure:
Prerequisites:
- Make sure that the network device works normally.
- Log in to the ZXA10 C220 through HyperTerminal or Telnet.
Context:
The ZXA10 C220 supports only one type of racks: ZXPON.
To configure the rack, performs the following steps:
Step-1. Use the configure terminal command to enter global configuration mode.
Step-2. Use the add-rack command to configure rack.
Note: The ZXA10 C220 supports only one rack at present, thus the rackno can only be 0.
Step-3. Use the show rack command to query rack configuration.
ZTE OLT Rack Configure Example:
Configure rack 0, and the rack type is ZXPON.
ZXAN#configure terminal
Enter configuration commands, one per line. End with CTRL/Z.
ZXAN(config)#add-rack rackno 0 racktype ZXPON
[bodyads]
Shelf Configure:
Prerequisites:
- Make sure that the network device works normally.
- The rack is configured.
- Log in to the ZXA10 C220 through HyperTerminal or Telnet.
Context:
The ZXA10 C220 supports two types of shelves:
- ZXA10C220-A: the slot 1 of which supports only the power card.
- ZXA10C220-B: the slot 1 of which does not support the power card.
To configure the shelf, performs the following steps:
Step-1. Use the configure terminal command to enter global configuration mode.
Step-2. Use the add-shelf command to configure shelf.
Note: ZXA10 C220 supports only one shelf at present, thus shelfno can only be 0.
Step-3. Use the show shelf command to query shelf configuration.
ZTE OLT Shelf Configure Example:
Configure shelf 0, and the shelf type is ZXA10C220-B.
ZXAN#configure terminal
Enter configuration commands, one per line. End with CTRL/Z.
ZXAN(config)#add-shelf shelfno 0 shelftype ZXA10C220-B
ZXAN(config)#show shelf
Rack Shelf ShelfType HwNo CleiCode
—————————————————————-
0 0 ZXA10C220-B 0 ZXA10C220-B_CleiCode
